Enable User Read/Write In Admin Mode; Set Global Read-Only In Admin Mode - iStorage DISKASHUR M2 Manuel De L'utilisateur

Note:
To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid

19. Enable User Read/Write in Admin Mode

To set the diskAshur M back to Read/Write, first enter the "Admin Mode" as described in section 5. Once the drive is in
2
Admin Mode (solid BLUE LED) proceed with the following steps.
1. In Admin mode, press and hold down both "7 + 9"
buttons.
2. Press the KEY ( ) button once
Note: To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid

20. Set Global Read-Only in Admin Mode

When the Administrator configures the diskAshur M
write to the drive and both are restricted to Read-Only access. Only the Administrator is able to change the setting back to Read/Write as
described in section 21.
and restrict Global access to Read-Only, first enter the "Admin Mode" as described in section 5. Once the drive
To set the diskAshur M
2
is in Admin Mode (solid
BLUE
1. In Admin mode, press and hold down both "5 + 6"
buttons.
2. Press KEY ( ) button
Note: To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
LED), press and hold down the SHIFT ( ) button for a second - the
BLUE
RED LED.
BLUE LED), press and hold down the SHIFT ( ) button for a second - the
RED LED.
and restricts it to Global Read-Only, then neither the Administrator nor the User can
2
LED) proceed with the following steps.
BLUE LED), press and hold down the SHIFT ( ) button for a second - the
RED LED.
www.istorage-uk.com
Solid BLUE LED will change to blinking
BLUE LEDs
GREEN and BLUE LEDs change to a solid
LED then to a solid BLUE LED
indicating the drive is configured as Read/Write
Solid BLUE LED will change to blinking
BLUE LEDs
GREEN and BLUE LEDs will change to a solid
GREEN LED and then to a solid
indicating the drive has been configured and
restricts Global access to Read-Only
GREEN and
GREEN
GREEN and
BLUE LED
#17