Maintenance; Fuses Replacement; Cleaning; Information On Disposal And Recycling - Videotec COMB Manuel D'instructions

8 Maintenance

8.1 Fuses replacement

CAUTION! For continued protection against
risk of fire, replace only with same type and
rating of fuse. Fuses must be replaced only
by service personnel.
If necessary, the connector board's fuses can be
replaced (6.1.1 Connector board description, page
13). The new fuses must comply with the directions
given in the table.
FUSES REPLACEMENT
Supply voltage Fuse (F1)
from 220Vac up to T 4A H 250V 5x20
230Vac, 50/60Hz
24Vac, 50/60Hz T 8A H 250V 5x20
from 120Vac up to T 4A H 250V 5x20
127Vac, 50/60Hz
Tab. 6

9 Cleaning

Frequency will depend on the type of
environment in which the product is used.
Avoid ethyl alcohol, solvents, hydrogenated
hydrocarbide, strong acid and alkali. Such
products may irreparably damage the
surface.
Cleaning should be done with mild soap diluted with
water.
18
10 Information on disposal
and recycling
The European Directive 2012/19/EU on Waste
Electrical and Electronic Equipment (WEEE) mandates
that these devices should not be disposed of in the
normal flow of municipal solid waste, but they should
be collected separately in order to optimize the
recovery stream and recycling of the materials that
they contain and to reduce the impact on human
health and the environment due to the presence of
potentially hazardous substances.
Fuse (F2)
T 8A H 250V 5x20
The waste may be delivered to appropriate collection
T 8A H 250V 5x20 centers, or may be delivered free of charge to the
distributor where you purchased the equipment at
T 8A H 250V 5x20
the time of purchase of a new equivalent or without
obligation to a new purchase for equipment with size
smaller than 25cm (9.8in).
For more information on proper disposal of these
devices, you can contact the responsible public
service.

11 Troubleshooting

When contacting VIDEOTEC for assistance please
provide the serial number and the identification code
of the model.
PROBLEM
CAUSE
SOLUTION
The symbol of the crossed out bin is marked
on all products to remember this.
Contact the VIDEOTEC technical service
or an authorized support centre if the
problems listed below persist or you have
any other issues that are not described
here.
The product does not go on.
Wiring error, blown fuse.
Make sure the connections are
correct. Check the continuity of
the fuses and replace them with
the indicated models should they
fail.
MNVCCOMB_2131_EN