Switching On - Videotec COMB Manuel D'instructions

Arrange the fibre optics as indicated in the figure, use
the nylon ties supplied to fasten them (Fig. 17, page
17).
Fig. 17
MNVCCOMB_2131_EN
Position the splice tray in place and fasten it using the
previously removed screws (Fig. 18, page 17).
Fig. 18
Apply threadlocker in the fastening screws
(Loctite 243®).
Pay attention to the fixing. Screws
tightening torque: 1.6Nm.

7 Switching on

The unit is switched on by connecting the power
supply.
To switch off the unit disconnect the power.
17