Description Of The Switch Board; Ethernet Cables Connection; Using The Splice Tray - Videotec COMB Manuel D'instructions

6.1.8 Description of the switch board

DESCRIPTION OF THE SWITCH BOARD
Connector Function
J1 RJ45 Ethernet Connector
J3 RJ45 Ethernet Connector
J5 RJ45 Ethernet Connector
J2 SFP connector
Tab. 5
J1
J2
J2
Fig. 15
Operation of the RJ45 connectors is signalled by the
relevant two LEDs:
• Yellow LED: LED on, indicates the connection is
enabled.
• Green LED: LED on, indicates the connection speed
is 100Mbps; LED off, indicates the connection
speed is 10Mbps.
Operation of the SFP connector is signalled by the
relevant three LEDs:
• Yellow LED: LED on, indicates the connector is
enabled.
• Red LED: LED on, indicates the fibre optic signal
has pinged;
• Green LED: LED on, indicates the connection speed
is 100Mbps.
16
J3
J1 J3 J5
J5

6.1.9 Ethernet cables connection

The devices to connect can be connected
indifferently to the RJ45 ports and/or to the SFP
module.
The switch board can manage up to 3 RJ45 ports and
is equipped with a slot for SFP modules.
Connect the Ethernet cables to ports RJ45, J1, J3, J5
connectors. Insert the SFP module (not supplied) in
Slot J2 of the switch board (6.1.8 Description of the
switch board, page 16).
Consult the SFP module manual for the relevant
specifications.
VIDEOTEC has tested various types of SFP
modules. For further information please
contact the VIDEOTEC service center.
Consult the installation manuals of the devices to
connect for specifications on the Ethernet cable.

6.1.10 Using the splice tray

COMB is equipped with a splice tray to host the fiber
optics.
Remove the screws (01) and take out the splice tray
(02) (Fig. 16, page 16).
01
Fig. 16
01
02
MNVCCOMB_2131_EN