Warn 93720 Instructions D'installation page 6

9. Install contactor to mounting plate using hardware supplied
with winch kit.
10. Install contactor mounting plate to vehicle frame using M6
hardware supplied.
11. Install winch control switch in a preferable location. See
winch kit instructions.
12. Review switch wiring details found in the winch kit
instructions. Keyed power is available in the white wire
of the red connector found near the contactor mounting.
Verify the keyed power wire using a 12 volt test light.
Connect the winch switch red wire to the keyed power wire
using the blue splice connector supplied with the winch kit.
©2014 Warn Industries, Inc.WARN® and the WARN logo are trademarks of Warn Industries Inc.
6
Red Connector
93721A1