Klarstein 10033131 Mode D'emploi page 30

EN
30
• Wipe the fixed parts of the burner cup with a damp cloth and dry afterwards .
• Gently wipe the ignition device and flame supervision device with a well wrung-out
cloth and wipe dry with a clean cloth.
• Before placing the burners back on the top plate, make sure that the injector is not
blocked.
Re-assemble the Auxiliary, Semi-Rapid, Rapid and Triple-Crown burners as
follows
1. Place the flame spreader ( 4 ) on to the burner cup ( 5 ) so that the ignition device
and the flame supervision device extend through their respective holes in the
flame spreader.The flame spreader must click into place correctly.
2. Position the burner lid ( 1,2,3 ) onto the flame speader ( 4 ) so that the retaining
pins fit into their respective recesses.
Warning: Danger of fire
Do not mix up the top and bottom.
The locating pins must fit exactly into the notches.