Getting Started - Ribiland PRTARTH2 Manuel D'instructions Et D'utilisation

IV. GETTING STARTED
4.1- Unpacking
Remove product from its packaging.
Check that product and accessories are not damage.
4.2- Content
The unit package contains:
- Power unit
- 1 drill bit L80cm x 15cm
- 1 mixing tank 600 ml,
- 1 multi-function spark plug wrench,
- 2 Allen keys,
- 1 reversible head screwdriver,
- 1 spanner,
- Manual
4.3- Assembly
WARNING - The bit has sharp edges and sharp point.
- Use protective gloves for safety.
4.3- Installing the bit
INSTALLATION OF THE DRILL BIT (Fig.3)
1. Insert the tube of the bit (12) into the connection shaft (11)
of the auger.
2. Insert the screw (a) through the hole of both the bit and shaft
and secure the assembly with the pin (b).
WARNING! CAUTION - WHEN EXCESSIVE
VIBRATION OCCURS, STOP ENGINE
Fig.3
IMMEDIATELY
Excessive vibration of bit means that it is not properly installed.
Stop the engine immediately and check bit.
A bit that is not properly installed will cause injury.
4.4- Fuel
WARNING!
1. Gasoline is highly flammable.
Avoid smoking or bringing any flame or sparks near fuel storage or refuel area.
2. Make sure to stop the engine and allow it cool before refuelling the unit.
3. Select outdoor bare and open ground for fuelling and move at least 3 m (10 ft) away from the
fuelling point before starting the engine.
4. Use an anti-oxidant added quality oil expressly labelled for air-cooled 2-cycle engine use
ASPEN
We recommend the use of Aspen 2 fuel.
This ready for use mixture contains no benzene or lead. It is distinguished by high octane and has the
advantage of always ensuring appropriate mixing ratio.
Aspen2 fuel is suitable for 2-stroke engines and ensures its durability.
Page 28 / 52