Ribiland PRTARTH2 Manuel D'instructions Et D'utilisation page 26

TRANSPORT
1. To transport the machine, cover the drill if necessary, lift the machine and transport it paying attention to
the drill.
2. Never transport the machine on uneven road and over a long distance without emptying the fuel tank
completely. Otherwise the fuel could leak from the tank during the journey.
3. When transporting in or on a vehicle, be sure to secure the product securely with no parts protruding
outside the vehicle, in order to avoid a hazard (e.g. machine falling from the vehicle, damage to the
vehicle ...)
a. Check damaged parts
- Before further use or reuse of the product, it should be carefully checked to determine that it will
operate properly and perform its intended function.
- Check for alignment of moving parts, free running of moving parts, breakage of parts, mounting and
any other conditions that may affect its operation.
- The safety devices and damaged parts must be repaired or exchanged by a recognized, specialist
workshop unless other information is mentioned in the manual.
- Damaged or illegible safety labels must be replaced.
b. Warning
The use of any accessory or attachment, other than those recommended in this instruction manual,
may present a risk of injury to persons or animals and may cause damages.
The user and/or operator are responsible for any damages or injury caused to properties and/or
persons.
c. Have your product repaired by qualified personnel
Unless otherwise indicated in this instruction manual, repairs or replacement of any damaged part in
an authorised service centre is recommended.
This product is in accordance with the relevant safety requirements. Repairs should only be carried
out by qualified persons using original spare parts, otherwise this may result in considerable danger
to the user.
d. Remarks:
The safety precautions and instructions given in this manual are unable to cover in detail all the
conditions and situations that may arise.
The operator and/or user must use common sense and caution when operating the product especially
for any matters that are not referred in the above
e. Note: For specific maintenance and safety information about this product, consult the user's
manual provided with it. If it has been lost or misplaced, contact your local retailer for a replacement.
f. Important: The information contained in this instructions manual describes components available
at the time of publication. We reserve the right to make changes without prior notice and without
obligation to make alterations to components previously manufactured.
g. Residual risks
Residual risks may be reduced when the user carefully follows the "safety instructions" and the use of
the product "in accordance with its intended purpose" as well as all instructions stated in this manual.
Awareness and caution reduce risk of injury and damage.
Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors.
The following hazards may arise in connection with the tool's construction and design:
- Ignoring or omitting to follow the safety precautions may result in injury or damage.
- Moving parts may cause injury to hands or feet whenever the user is careless, does not follow the
safety instructions or when he uses the machine for other purposes.
- Spilled fuel may pose a risk of slipping for the operator and fire.
5. After refuelling, screw the fuel cap back tightly onto the fuel tank and then carry
the unit to a spot 3 m or more away from where it was refuelled before turning on
the engine.
6. Reminder: Gasoline must be stored and transported in approved containers.
Page 26 / 52