Working Plan; Before Starting The Engine - Ribiland PRTARTH2 Manuel D'instructions Et D'utilisation

WORKING PLAN

1. You should never use the product when under the influence of alcohol, when
suffering from exhaustion or lack of sleep, when suffering from drowsiness as a
result of having taken cold medicine or at any other time when a possibility exists
that your judgment might be Impaired or that you might not be able to operate the
product properly and in a safe manner.
2. When planning your work schedule, allow plenty of time to rest.
Limit the amount of time over which the product is to be used continuously to
somewhere around 40-60 minutes per session and take 10-15 minutes of rest
between work sessions. Also try to keep the total amount of work performed in a
single day under 2 hours or less.
3. DO NOT let a sense of ease and familiarity with the product (gained from
repeated use), replace strict adherence to safety instructions that come with the
machine. If you do not use this machine in a safe and adequate way, you run a risk
of severe injury.
Warning: If you don't observe the working time or working manner,
Repetitive Stress Injury (RSI) could occur.
If you feel discomfort, redness and swelling of your fingers or any other part of
your body, see a doctor before getting worse.
NOTE: To avoid noise complaints, check and follow the local regulations as to
sound level and hours of operations for the product.

BEFORE STARTING THE ENGINE

1. Delimit the working perimeter: The area within a perimeter of 5m of the
machine and operator of the machine should be considered a hazardous area into
which no one should enter.
If necessary, place warning tape, warning signs around the working area perimeter.
When two or more people work together or near each other, they must constantly
be careful and keep their distance from each other to ensure satisfactory safety.
2. Be aware of your surroundings, constantly check the condition of the work area
to avoid any accident caused by stumps, stones ...
IMPORTANT: remove any obstacle before beginning work.
3. Check that all parts of the unit are tight and that there are no fuel leaks.
Check that the drill is properly mounted and locked.
STARTING THE ENGINE
1. Prevent any person or animal from approaching within 15 meters.
If someone gets too close, stop the engine immediately.
2. This product is equipped with a centrifugal clutch, so that the drill starts rotating
as soon as the throttle lever is activated.
To start the engine, place and hold the machine flat on the ground in an open area
where no obstacles can come into contact with the drill or the throttle lever.
WARNING! Never turn the throttle lever all the way down when starting up.
3. Once the engine is running, check that the drill is no longer moving when the
throttle is fully returned to its starting position. If it continues to rotate after
returning the throttle to the original position, turn off the engine and have your unit
serviced by the authorized service center.
Page 24 / 52