Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
c. Torque adjustment (Fig.5)
Fig.5
d. LED worklight (Fig.6)
Fig.6
e. Dual range gear switch (Fig.7)
Fig.7
180716_ayce_5260.1_IM
•
The cordless drill has a 23+1 drill step
torque adjustment, in order to avoid
damage to the screw-heads or drill s.
•
By turning the torque adjusting
ring on your drill, you can set the
necessary step.
•
Always select the appropriate torque
for the work in hand at the time.
•
The tool has LED light to illuminate
the work area and improve vision
when working in areas with
insufficient light. The LED light will
switch on automatically while the on/
off switch is turned on.
•
Adjust speed by selecting the dual
range gear switch to set desired
speed.
•
To select the low speed, high torque
setting, turn the tool off and let the
motor come to a complete standstill.
Push the dual range gear switch
backward.
•
To select high speed, low torque, turn
the gear switch forward.
f. bit storage (fig.8)
Fig.8
g. Switch on and off (Fig.9)
Fig.9
h. Belt clip (Fig.10)
Fig.10
102 103
|
•
The tool is equipped with one bit
storage which is located on the rear of
the tool. It is convenient to store your
double-end bit in it.
•
Squeeze the trigger switch to start
the drill. And allow the drill reaches
full speed before beginning drilling.
•
After completing your drilling, release
the trigger switch, allow the bit to
come to a complete stop before
setting the drill down.
•
The tool is equipped with a belt clip
which is located on either side of the
tool. It can be attached conveniently
on the belt loop or the pant pocket,
the user is saved from the hassle
of picking up or putting down the
equipment every time its use is
required.
180716_ayce_5260.1_IM
GB
GB
Publicité
Table des Matières
