Ayce 5260.1 Manuel D'utilisation page 50

Recycle unwanted materials instead of disposing of them. All
appliances and packaging should be sorted and tendered at a
regional recycling centre into to be processed in an ecological
manner.
Proven safety of the federal inspectorate for heavy current
installations ESTI
2. Product symbols
In this manual and/or on the machine the following symbols are may used. These
represent important information about the product or instructions on its use.
20V 2.0Ah Li-ion battery
AKKU
pack
Li-Ion20V
2.0Ah
0-450/0-1600/min
min -1
variable speed
0-450
0-1600
13mm keyless plastic
chuck
Ø 13mm
Forward/reverse
function
R L
180716_ayce_5260.1_IM
Max. torque 45Nm
45Nm
80min Charging time
80 min
With a LED worklight
to illuminate the work
area
LED
OPERATION
1. Before use
• Remove any packing material and loose parts from unit.
• Check the accessories before use. They should fit with the machine and your
purpose.
• If the machine is new, the battery must first be charged.
Attention! After long time storage, the battery capacity will be reduce.
A new battery or one which has not been used for an extended period achieves full
performance only after approx.1 hour charging and discharging cycles. A substantial
drop in operating period per charge indicates that the battery is worn out and must be
replaced.
2. Battery charger (Fig.1)
Fig.1
a. charging the battery
This lithium-ion battery pack is shipped partially charged. Before using it the first
time, fully charge the battery pack. A fully discharged battery pack with a temperature
between 0°C and 40°C will charge in about 80min.
• Charge the lithium-ion battery pack only with the correct charger.
• Connect the charger to a power supply.
• Attach the battery pack to the charger by aligning the raised ribs on battery pack
with the grooves in the charger insert the battery pack into the charger, making
sure the battery pack is fully seated.
98 99 |
• The lithium-ion battery can be
charged at any time and will not
develop a "memory" when charged
after only a partial discharge. It is not
necessary to run down the battery
pack charge before recharging.
Remove the battery pack from the
tool when convenient for you and your
job. You can "top-off" your battery
pack's charge before starting a big job
or long period of use.
• Due to lithium-ion's fade-free
properties, the only time it is
necessary to charge the lithium-ion
battery pack is when the pack has
reached the end of its charge. To
signal the end of charge, power to
the tool will drop quickly. Charge the
battery pack as needed.
180716_ayce_5260.1_IM
GB
GB