Further Electrical Connections On The Cm-Rc-01; Laying The Cables - Bitzer CM-RC-01 Instructions De Montage

▶ Attach the connection cap and tighten the screw
(position and downward cable routing, see figure).
Next, any optional extension kits can be mounted (see
chapter Mounting the optional CM-RC-01 extension
kits, page 22).
3.6 Further electrical connections on the CM-
RC-01
• Voltage supply of the compressor module on ter-
minal strip CN1 (115 .. 230 V +10%/-15%,
50/60 Hz):
– Terminal 1: L
– Terminal 2: N
• Command for compressor start (release signal from
system controller).
• Optionally: Analogue signal for capacity control from
the system controller (0 .. 10 V).
Schematic wiring diagram and further information, see
Technical Information KT-230.
KW-231-2

3.7 Laying the cables

4-cylinder compressors 4JE-13Y .. 4FE-35(Y):
▶ Lay the cables along the cable holders and use
cable ties to fix them.
The figure shows the compressor with components of
the optional extension kits.
6-cylinder compressors 6JE-22Y .. 6FE-50(Y):
▶ Lay the cables along the cable holders and use
cable ties to fix them.
The figure shows the compressor with components of
the optional extension kits.
21