Removal Of Seat And Cover; Troubleshooting - Roca IN-WASH INSPIRA Mode D'emploi

4.7 REMOVAL OF SEAT AND COVER

❚
To remove the seat and cover, slide the internal side tab upwards and carry out the movement described in the image; raise the side of the turned tab and
slide it sideways towards the opposite side.
4
To replace the seat and cover carry out the operation in reverse.
Important warning:
If you remove the dampers when extracting
the seat and cover, it is important to take into
account their position, as a change in their
position may seriously damage the product.
The white damper is located on the right side
(to cushion the seat) and the grey one is on
the left (to cushion the cover).

5. TROUBLESHOOTING

PROBLEM
The product does not respond to the auxiliary
side panel
The product does not respond when pressing
the remote control or the leds of the remote con-
trol do not switch on.
All leds in the remote control are blinking.
The product does not respond when pressing
the remote control and the leds in the functions
area of the remote blink.
No function activates and a beep can be heard.
The water flow is lower than usual and the lights
blink three times every 5 seconds.
1
Gray
Gris
L
POSSIBLE CAUSE
The device is turned off.
The product is unplugged or disconnected.
The batteries of the remote control are dead.
The batteries of the remote control are not pro-
perly placed.
The batteries in the remote control are running
low.
The device is turned off.
The remote control is not connected to the e-bi-
det.
The remote control cannot be connected to the
e-bidet. (The batteries are new and they are co-
rrectly placed).
The user is not seated properly and the sensor
is not working.
The water outlets in the tip might be blocked due
to limescale.
3
5
R
SOLUTION
Press the Stop button on the auxiliary side panel.
Connect the device to the mains.
Replace the batteries. (See 4.1.4).
Verify that the batteries are placed in the correct
*
position (See 4.1.4).
Replace the batteries.
Press the Stop button on the auxiliary side panel.
Connect the remote control. (See 2.2.1)
*
*
Correct your position.
Descale the tip (See 4.1.2) and reset the product.
*
(See 3.6)
2
6
Blanco White
23