Maintenance Precautions; Environmental Conditions; Introduction; Product Parts - Roca IN-WASH INSPIRA Mode D'emploi

To lean back when you are sitting on the In-Wash will facilitate the adjustment of the nozzle and will
reduce possible splashing.
Do not urinate or splash water or cleaning agents on the main body or the mains plug.
If you do it, you may cause a fire, electric shock, heat or a short-circuit and you may cause stains or
a malfunction.
Do not ever obstruct any opening in the product, nor should you drop or insert any objects in them.
Keep the air inlet free of lint.
Do not place any open flames, candles, cigarretes or similar items over the product and do not drop
flammable items or cigarretes near or inside the product.
Do not step on the product.
Avoid forcing the seat or the cover.
Please do not bend, pull or twist the power cable, nor should you place heavy objects on it.
If there is a water leak, always close the shut-off valve.
Do not use a booster seat for children or adults if you are going to use the In-Wash.
To avoid dropping the remote control, place it on its base when you are not using it.

1.1.4 MAINTENANCE PRECAUTIONS

Stop the product if you are not going to use it for a long period of time. (Check section 3.6 of this
manual).
Do not disassemble or repair the product; please contact Technical Assistance in case of breakdown.
Any repairs should be carried out by authorised staff, using original spare parts and accessories.
When you use cleaning agents to clean the WC, clean it and remove it in 3 minutes, leaving the seat
and cover always open.
Clean any remains of detergent from the WC bowl. (If the vapour from a WC cleanser enters the main
unit, it may cause a malfunction).
❚

1.2 ENVIRONMENTAL CONDITIONS

The room temperature should not be below 4ºC or over 40ºC.
When the room temperature drops below 4ºC, avoid damages due to freezing; frozen water pipes
could break the In-Wash and the pipes, resulting in a water leak; regulate the room temperature to
prevent the pipes and hoses from freezing during the cold months.

2. INTRODUCTION

❚

2.1 PRODUCT PARTS

See Fig. 1
❚

2.2 START-UP

2.2.1 CONNECTION OF THE REMOTE CONTROL AND SELF-CALIBRATION

To connect the remote control to the In-Wash it is necessary to:
1 2
CR 2032 (x2)
3 4
ON
Max. 60 s.
5
AUTO-CALIBRACIÓN
5 s.
120 s.
17