Freezer Compartment / Cleaning / When The Appliance Is Not In Use / Changing The Light Bulb - Electrolux IK2065RE Mode D'emploi

Freezer compartment
•
Remove the frost with a plastic scraper,
•
Whenever the thickness of the frost exceeds 5 mm
complete
defrosting should be carried out.
Prooceed as follows:
•
Remove any stored food, wrap it in several layers
of newspaper and put it in a cool place.
•
Pull out the plug from the wall socket or turn the
ther-mostat knob to the «O» setting.
•
Leave the door open, place a basin on the top shelf of
the refrigerator compartment, under the drain hole,
remove the plug as shown in the figure.
•
When defrosting is completed, dry the interior thor-
oughly and refit the plug.
•
Turn the thermostat knob back to the required set-
ting or replace the plug in the power socket.
•
Reload the previously removed food into the com-
partment.
Never use sharp metal tools to scrape off frost
from the evaporator as you could damage it.
Do not use a mechanical device or any arti-
ficial means to speed up the thawing process
other than those recommended by the manufacturer.
Cleaning
Never use metal objects for cleaning your
appliance as it may get damaged.
NEVER use detergents, abrasive powders, highly
perfumed cleaning products or wax polishes to
clean the interior as these will damage the surface
and leave a strong odour.
Clean the inside with warm water and bicarbonate of
soda. Rinse and dry thoroughly..
When the appliance is not in use
Disconnect the appliance from the electricity supply.
Empty all foods and clean the appliance, leaving the doors
ajar to prevent unpleasant smells.
Changing the light bulb
•
Should the interior light fail to work, first switch off
the appliance and disconnect from the electricity sup-
ply.
Press on the rear hook and at the same time slide
the cover in the direction indicated by the arrow.
Replace the lamp with one of the same power
(the maximum power is shown on the light
diffuser).
19