Kohler SOK K-1188 Guide D'installation page 9

5. Position the Unit
CAUTION: Risk of product damage. Do not lift or support the overflowing bath by the pump or
piping.
NOTE: Do not use adhesive or a cement or mortar bed to secure this product to the subfloor.
With help, carefully lift the overflowing bath into place.
NOTE: If you do not have a 4' (1.2 m) level, go to the next section.
Level by turning the adjustable feet up or down with the wrench (7/8") attached to the harness near the
pump. Make sure all four adjustable feet rest directly on the subfloor, and make sure the bathing well rim
is level within 1/8" (3mm) in all directions.
After the overflowing bath is level, adjust the leveling foot located underneath the pump. Turn the foot
until it rests directly on the subfloor. Use an accurate 4' (1.2m) level, if available. Taking the time to
carefully level the overflowing bath now minimizes the need to make leveling adjustments later in the
installation.
Cut and discard the banding straps from the pump.
Insert the drain tailpiece into the trap.
Kohler Co. 9 1005288-2-D