Makita HTR5600 Manuel D'instructions page 4

Starting up the Hedge Trimmer
– Please make sure that there are children or other people within a working
range of 50 feet or 15 meters (5), also pay attention to any animals in the
working vicinity.
– Before operating, always check that the Hedge Trimmer is safe for
operation:
Check the security of the throttle lever. The throttle lever should be checked
for smooth and easy action. Check for proper functioning of the throttle lever
lock. Check for clean and dry handles and test the function of the STOP
switch. Keep handles free of oil and fuel.
Start the Hedge Trimmer only in accordance with the instructions.
Do not use any other methods for starting the engine (6)!
– Use the Hedge Trimmer only for applications specified.
– Start the Hedge Trimmer engine only after the entire assembly is done.
Operation of the Hedge Trimmer is permitted only after all the appropriate
accessories are attached!
– Before starting, make sure that the cutter blade will not contact any objects
such as branches, stones, etc.
– The engine is to be stopped immediately if there are any engine problems.
– When working with the Hedge Trimmer, keep both hands on handles always
wrap your fingers tightly around the handle, keeping the control handle
cradled between your thumb and forefinger. Keep your hand in this position to
have your machine under control at all times. Make sure your control handle
is in good condition and free of moisture, pitch, oil or grease.
Always ensure a safe, well-balanced footing.
– Only use outdoors.
– Operate the Hedge Trimmer in such a manner as to avoid inhalation of the
exhaust gases. Never run the engine in enclosed rooms (risk of suffocation
and gas poisoning). Carbon monoxide is an odorless gas. A lways ensure
there is adequate ventilation.
– Stop the engine when resting and when leaving the Hedge Trimmer
unattended. Place it in a safe location to prevent danger to others, setting fire
to combustible materials or damage to the machine.
– Never lay down the hot Hedge Trimmer onto dry grass or onto any
combustible materials.
– Never operate the engine with a faulty exhaust muffler.
– Stop the engine during transport (7).
– Secure the tool properly before transporting in vehicle to avoid fuel leakage.
– When transporting the Hedge Trimmer ensure that the fuel tank is completely
empty to avoid fuel leakage.
Refuelling
– To reduce the risk of fire and burn injury;; handle fuel with care.
It is highly flammable.
– Stop the engine before refuelling (7), keep well away from open flame (8) and
do not smoke.
– Do not attempt to refuel a hot or a running engine.
– Avoid skin contact with petroleum products. Do not inhale fuel vapor. A lways
wear protective gloves during refuelling.
Change and clean protective clothing at regular intervals.
– Take care not to spill either fuel or oil always wipe unit dry before starting
engine. A llow wet cloths to dry before disposing in proper, covered container
to prevent spontaneous combustion.
– Avoid any fuel contact with your clothing. Change your clothing immediately if
fuel has been spilled on it (danger hazard).
– Inspect the fuel cap at regular intervals making sure that it stays securely
fastened.
– Carefully tighten the locking screw of the fuel tank. Move at lease 10 ft
(3 meters) away from the refuelling point before starting engine.
– Never refuel in closed rooms. Fuel vapors accumulate at ground level (risk of
explosions).
– Only transport and store fuel in approved containers. Make sure stored fuel is
not accessible to children.
– When mixing gasoline with two-­cycle engine oil, use only gasoline which
contains no ethanol or methanol (types of alcohol).
This will help to prevent damage to fuel lines and other engine parts.
– Make sure the unit is properly assembled and in good operating condition.
15 meters
(5)
(6)
• Resting
• Transporting
• Refuelling
• Maintenance
• Tool Replacement
(7)
(8)
(9)
4
(50 feet)
3 meters