Starting The Machine; Stopping The Machine - Makita HTR5600 Manuel D'instructions

STARTING THE MACHINE

Move at least 3 meters away from the place of refuelling. Place the
Hedge Trimmer on a clean area of ground make sure that the cutting
tool does not come into contact with the ground or any other objects.
Cold starting (When the engine is cold or it has been stopped for more
than 5 minutes or when fuel is added to the engine.)
1. Push the STOP switch (1) to "I" position.
2. Squeeze first the lock lever A and then the throttle lever B. (fig.1)
3. Keeping the throttle lever B depressed, then press the throttle lock C
inward. (fig. 2)
4. Keeping throttle lock C depressed, release the throttle lever B.
this will lock the throttle lever B in position. (fig. 3)
5. Give a gentle push on the primer pump (2) repeatedly (7 to 10 times)
until fuel comes into the primer pump.
6. Move the choke lever (3) to position (
7. Hold the unit down firmly so you will not lose control
while cranking the engine. If not held down properly,
the engine could pull you off balance or swing the
cutting blade into an obstruction or your body.
8. Slowly pull the starter grip until resistance is felt and
continue with smart pull until initial ignition are heard.
9. Depress the choke lever (3) to the position (
and pull the starter rope again until the engine starts.
10. As soon as the engine starts, immidiately tap and
release the throttle, thus releasing the half-­throttle
rock so that the engine can run in idle.
11. Run the engine for approximately one minute at a
moderate speed before applying full speed.
Hot staring: (Restarting immediately after the engine has stopped)
When restarting a hot engine, first try the above procedure: 1, 7, 8.
If the engine does not start, repeat above steps 1-­11.
NOTE: Do not pull the starter rope to its full extent and do not allow
the starter grip to be retracted without control, ensure that it is
retracted slowly.

STOPPING THE MACHINE

1. Release the throttle lever completely.
2. Push the I-­O switch (on/off switch) to "O" position,
the engine rotation will become low and the engine
will stop.
).
)
10
HTR7610
(1)
HTR5600
HTR7610
(2)
(3)
HTR7610
HTR5600
HTR5600