Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2
Information and general instructions
2.1
Information about the instruction manual
2.1.1
Introduction
The instruction manual supplied with the burner:
is an integral and essential part of the product and must not
be separated from it; it must therefore be kept carefully for
any necessary consultation and must accompany the burner
even if it is transferred to another owner or user, or to
another system. If the manual is lost or damaged, another
copy must be requested from the Technical Assistance
Service of the area;
is designed for use by qualified personnel;
offers important indications and instructions relating to the
installation safety, start-up, use and maintenance of the
burner.
Symbols used in the manual
In some parts of the manual you will see triangular DANGER
signs. Pay great attention to these, as they indicate a situation of
potential danger.
2.1.2
General dangers
The dangers can be of 3 levels, as indicated below.
Maximum danger level!
This symbol indicates operations which, if not car-
ried out correctly, cause serious injury, death or
long-term health risks.
DANGER
This symbol indicates operations which, if not car-
ried out correctly, may cause serious injury, death
or long-term health risks.
WARNING
This symbol indicates operations which, if not car-
ried out correctly, may cause damage to the ma-
chine and/or injury to people.
CAUTION
Information and general instructions
3
GB
2.1.3
Danger: live components
This symbol indicates operations which, if not car-
ried out correctly, lead to electric shocks with le-
thal consequences.
DANGER
Other symbols
ENVIRONMENTAL PROTECTION
This symbol gives indications for the use of the
machine with respect for the environment.
This symbol indicates a list.
Abbreviations used
Ch.
Chapter
Fig.
Figure
Pag.
Page
Sec.
Section
Tab.
Table
Delivery of the system and the instruction manual
When the system is delivered, it is important that:
The instruction manual is supplied to the user by the system
manufacturer, with the recommendation to keep it in the
room where the heat generator is to be installed.
The instruction manual shows:
– the serial number of the burner;
.........................................................................................
– the address and telephone number of the nearest Assist-
ance Centre.
.........................................................................................
.........................................................................................
.........................................................................................
The system supplier carefully informs the user about:
– the use of the system,
– any further tests that may be necessary before the system
is started up,
– maintenance and the need to have the system checked at
least once a year by the manufacturer or another special-
ised technician.
To ensure a periodic check, the manufacturer recom-
mends the drawing up of a Maintenance Contract.
20010950
Publicité
Chapitres
Table des Matières
