Final Steps - Canarm TRI-LITE HVLS Serie Mode D'installation

TRI-LITE HVLS SERIES FANS

FINAL STEPS

IMPORTANT LEVELLING INSTRUCTIONS:
After your fan is installed, check the level again by placing your
level vertically on the side of the fan frame.
If adjustment is needed slightly tighten the guy wire on the
appropriate side.
Once levelled your fan is installed and ready for electrical
installation / connection.
For proper electrical connection, please consult the motor
wiring diagram (supplied with the motor).
WARNING! TO REDUCE THE RISK OF FIRE, ELECTRIC
!
SHOCK OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
• Only qualified electricians are allowed to install the
drive and connections to the motor.
ATTENTION!
1. Remove rubber plug prior to start up.
2. Discard rubber plug after removal.
3. Discard pink tag if attached to unit.
3. If yellow sticker is attached to unit, it can remain in place.
ITEMIZED CHECKLIST
WP Blade Set
16', 24'
Fan Control AC Tech VFD
ESV751N02YXB (NEMA1) 230V, 1/3PH INPUT
ESV751N04TXB (NEMA1) 460V, 3PH INPUT
HVLS-ESV751N02YXC (NEMA4) 230V, 1/3PH INPUT
HVLS-ESV751N04TXC (NEMA4) 460V, 3PH INPUT
TRI-LITE HVLS-M (04_29_15)
AND
Packaged UMH Mount
1', 2', 4'
YELLOW STICKER
PINK TAG
WP Fan Package
16', 24'
OPTIONAL COMPONENT
Packaged Extension Mount
2', 4'
HVLS-MBX2, HVLS-MBX4
FIGURE 14
Page 8 of 13