Philips Senseo Sarista HD8030 Mode D'emploi page 11

Masquer les pouces Voir aussi pour Senseo Sarista HD8030:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4203_000_7242_2_DFU-Luxury_A5_v1.indd 11
2
Make sure the bean-funnel is attached properly and contains enough
beans to brew a jug of coffee.
Note: The coffee beans have to be visible above the jug indication of the
bean-funnel. If this is not the case, there are not enough coffee beans in the
bean-funnel to brew six cups of coffee. Replace the bean-funnel with a full one
or one that contains enough coffee beans (see chapter 'Before first use').
Note: If the bean-funnel becomes empty during brewing, the 'bean-funnel
empty' light goes on and the coffeemaker stops during brewing. Replace the
bean-funnel with a full one or one that contains enough coffee beans (see
chapter 'Before first use') and press the jug button to continue brewing.
3
Remove the detachable coffee spout, if present.
4
Always empty the coffee grounds container and the drip tray before
you start brewing a jug of coffee.
Note: If you do not empty the drip tray, the drip tray may overflow during brewing.
Note: If you do not empty the coffee grounds container, the 'coffee grounds
container full' light may go on and the coffeemaker may stop during brewing.
Make sure the appliance is switched on when you empty the coffee grounds
container. Take it out of the appliance for 3 seconds until the bean-funnel
empty light stops flashing before placing it back. Press the jug button to
continue brewing coffee.
5
Turn the lid of the jug by its lever to 'closed/brewing' position. In
this position, the arrowhead on the jug handle points to the 'closed/
brewing' symbol on the jug lid.
6
Place the jug on the drip tray cover.
Tip: To keep the coffee hot longer, rinse the jug with hot water to preheat it
before you start brewing coffee.
EnglisH
11
1/9/13 1:37 PM

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Senseo sarista hd8010

Table des Matières