Operation; Prior To Start-Up; Connection; Disconnection - Bosch C1 Notice D'utilisation

Operation

Prior to start-up

3 Read the battery operating instructions before
connecting up the charger.
3 Observe the vehicle manufacturer's
recommendation if the battery is still
connected to the vehicle.
3 Clean the battery terminals. When doing so,
do not allow the dirt to come into contact
with your eyes or mouth.
3 Ensure adequate ventilation. Hydrogen gas
(electrolytic gas) may escape from the battery
during charging and trickle charging.

Connection

3 Connect the (+) terminal (red) (5) of the
charger to the (+) terminal of the battery.
3 Connect the (–) terminal (black) (6) of the
charger to the (–) terminal of the battery.
3 The (–) terminal (black) (6) can also be
connected to the car body, however well
away from fuel pipes.
Note: Make sure the (+) and (–) terminals are firm.
3 Only then is the power cord to be connected
to the mains current.
04.2015 | C1 | Battery charger
C1-Komplett-040914.indd 17
As soon as the charger has been connected to the
mains current, it switches automatically to standby
mode. The "Power" indicator (7) will light up.

Disconnection

3 Switch the charger to standby by pressing
the Mode selection button (8).
3 Always start by disconnecting the power cord
from the mains current.
3 Disconnect the (–) terminal (black) (6)
of the charger from the (–) terminal of the
battery.
3 Disconnect the (+) terminal (red) (5)
of the charger from the (+) terminal of the
battery.

Mode selection

3 Select the required mode by pressing the
mode selection button (8).
3 The LED for the desired mode will light up.
17 | english
Automotive Aftermarket
08.05.15 10:08