Electromagnetic Compatibility; Electromagnetic Emissions - VOCO Celalux 2 Manuel D'utilisation

9 - SPECIFICATIONS
Handpiece
Model: C
Weight: 165 g
Size: Ø23 x 200 mm
Classification: Ordinary
Type B
Continuous service
IPX0
Power supply adapter
Input voltage:
Frequency:
Output voltage:
Output current:
Classification:
Base station
Input voltage: 12 V DC
Protection: Fuse 3 A T
Classification: Continuous service
IPX 0
Battery
Type: Lithium-Ion
Size: 90 x Ø21 mm
Capacity: 2000 mAh
Optical specifications
Wavelength: 420-480 nm
Intensity: 900 to 2000 mW/cm² ± 10%
(depending on light guide)
Temperatures
Operating: +10°C to +40°C
Storage: -20°C to +70°C
Humidity
Operating: 30% to 75%
Storage: 10% to 100%
2
ELALUX
110 - 240 V AC
47 - 63 Hz
12 V DC
800 mA
II
IP 40
10 - ELECTROMAGNETIC
COMPATIBILITY
Warning: The charger power cord must be kept apart
from those of any nearby devices.
C 2 requires special precautions to be taken with
ELALUX
regard to electromagnetic compatibility. It must be
installed and prepared for use as described in chapter 3.
Certain types of mobile telecommunication devices such
as mobile telephones are likely to interfere with the
C 2. The recommended separation distances in
ELALUX
this paragraph must therefore be complied with.
The C 2 must not be used near or on top of
ELALUX
another device.
If this cannot be avoided, its operation under the
conditions of use must be checked beforehand.
The use of accessories other than those specified or sold
by VOCO as replacement parts may have the
consequence of increasing the emissions or decreasing
the immunity of the C

10.1 - Electromagnetic emissions

The C 2 is intended for use in the electromagnetic
ELALUX
environment specified in the table below. The user
and/or installer must ensure that the C
in such an environment.
8
2.
ELALUX
ELALUX
2 is used