Troubleshooting; Midland G15 Pro Instruction Guide - Midland G15 PRO Guide D'utilisation

Troubleshooting

Problem
The radio doesn't
switch on
The radio switches
off shortly after it has
been switched on
The battery pack does
not recharge
The radio switches on
but is unable to receive
signals
It is not possible to
communicate with
other parties
Reception is fragmen-
ted and/or disturbed
The autonomy of the
battery pack is limited

Midland G15 PRO instruction guide

Possible Cause
The battery pack is discharged and/
or has not been installed correctly.
Discharged battery pack.
The battery-charger has not been
connected or installed correctly.
The site of installation is too
shielded.
The volume is too low
Incorrect CTCSS or DCS
An incorrect radio channel has
been selected.
The radio is installed in a shielded
area or is too far from the party
you are communicating with
Incorrect CTCSS or DCS
The signal is very weak.
The transmission distance is exces-
sive and/or there are obstacles in
the transmission path
Other parties are using the same
channel
The radio has been installed too
close to equipment that causes
interference (televisions, compu-
ters, etc.)
Commission time is too high.
Solution
Verify that the battery pack is
charged and that it has been
correctly installed.
Recharge the battery pack.
Inspect the connections of the
battery-charger and the installa-
tion of the batteries.
Move to an another area.
Adjust the volume level.
Check that the CTCSS tone or
DCS code corresponds to the one
set by the parties you are commu-
nicating with.
Select the same radio channel
used by the parties you are com-
municating with.
Move to another area.
Check that the CTCSS tone or
DCS code corresponds to the one
set by the parties you are commu-
nicating with.
Try temporarily disabling the
Squelch by means of the Monitor
feature.
Move closer to the party you are
communicating with or to another
area.
Check the traffic on the radio
channel by means of the Monitor
feature and select another channel
if required.
Increase the distance between the
radio and this equipment.
Try reducing the transmission time
and/or using a low power.
| 11