Battery Recharge; Roger Beep (End Transmission Tone); Keypad Beep - Midland G15 PRO Guide D'utilisation

CH17 - CH32
17 - 24: standard pre-set PMR446 channels
•
25 - 32 : pre-set PMR446 channels of the new band
•
The first 8 channels of the traditional band 446.0 - 446.1 allow you to com-
municate with all PMR446 radios on the market.

Battery recharge

G15 PRO is equipped for using a 7,4V Li-ion rechargeable battery pack which
can be recharged connecting the socket of the AC/DC wall adaptor to a mains
power socket and inserting the jack of the wall adaptor into the desktop char-
ger plug.
It takes 4 hours to fully recharge the radio. The led of the desktop charger
indicates the status of the recharge:
Red = charging, Green = full charge
For maximum battery life, we recommend charging the battery pack when the
G15 PRO is off and the battery pack is fully discharged.
! Using a different battery charger other than the one specified can cause
damage to your device or may even cause explosions and personal injuries.
The Battery power saving feature enables a reduction in consumption of up to
50%. If it has been set, it automatically activates when the transceiver does
not receive any signal for more than 5 seconds in order to save the battery life.
Power saving can be disabled only through Programming software.

Roger Beep (End transmission tone)

When the PTT button is released, the radio will beep to confirm to other users
that you've finished your transmission and that they can start talking.
The Roger Beep can be enabled through the programming software.

Keypad Beep

If this function is active, you will hear a beep tone everytime you press a button
(It can be disabled through the programming software).
8 | Midland G15 PRO instruction guide