Operating Instructions - ATEQ Orange Electronic OE46 Guide D'utilisation

7. OPERATING INSTRUCTIONS

7.1. TPMS TOOL O
Read and diagnose sensors, OBDII ECU reset and transfer data to ECU.
Note: With some vehicles, if the vehicle is in "learn mode" the vehicle will also confirm that the
TPM sensor has communicated to the ECU with a series of horn beeps.
Service Procedure
Section 1.0: Read Sensor Test
Before servicing the tires/wheels, using your TPMS TOOL,
trigger each of the vehicle's sensors to make sure they are
working properly.
This will eliminate the liability associated with replacing
previously damaged or defective sensors. This procedure will
not change the vehicle settings because the vehicle has yet to
be put into learn/retraining mode.
This procedure allows you to quickly identify damaged or defective sensors, because some
vehicles do not report a damaged or defective sensor condition on the instrument cluster for up to
20 minutes.
Note: If the sensors do not trigger, please refer to the Troubleshooting section of this Guide.
Perform tire/wheel service.
For vehicles that require retraining, please see Section 2.0
Section 2.0: Learning the TPM System
With the vehicle in learn mode, begin by triggering the driver's left
front (LF) wheel sensor. Many vehicles will provide an audible
beep confirming that the sensor ID has been learned by the
vehicle's on-board computer.
The communication between the sensor and the on-board
computer is also confirmed on LCD display of the TOOL.
The same procedure should be followed on all wheel sensors, in a clockwise
rotation, until all the vehicle sensors have been relearned.
For vehicles that do not require relearned, we recommend you trigger each wheel
sensor, one final time, to make sure they are working correctly prior to releasing the
vehicle to the customer.
UM-365OEA-U
VERVIEW
OE46 TPMS TOOL User Guide
1 LF
4 LR
User manual OE46 Page 8/34
RF 2
RR 3
Fig. 4