Cleaning; Cleaning Of The Blast Chiller; Cleaning The Probe - Finarome AT03ISO Notice D'utilisation

EN | Blast chillers | User and maintenance manual

3. CLEANING

All the procedures must be carried out with the stationary unit removing the tension from both the
refrigerated item and the condensing unit.

3.1 CLEANING OF THE BLAST CHILLER

The maintenance of the blast chiller must include at least one daily cleaning of the loading zone, in
order to prevent the development and the accumulation of bacteria.
Before cleaning the blast chiller room, carring out the defrosting keeping the door open and removing
the lid of the derainage pipe
ATTENTION
It is essential to keep daily clean the blast chiller in order to prevent the development and the accumulation of
bacteria. Before cleaning the chamber of the blast chiller, you must execute a defrosting process, by removing
the lid of the drainage basin.
• Do not fl ush directly the inner parts of the blast chiller because the electrical parts could get damaged.
• Do not use any hard metal tools to remove the ice.
• For the cleaning use only warm water (not hot) with no-aggressive detergents, taking care of
drying the wet parts with a soft cloth.
• Avoid to use products that contain chlorine or diluted solutions, caustic soda, abrasive detergents,
muriatic acid, vinegar, bleach or other products that might scratch or grind.
• We recommend to clean the device at least once a month, when it used for deep-frozen products.
Attention, during the cleaning operations it is recommended to use work gloves.

3.2 CLEANING THE PROBE

The maintenance of the blast chiller must include at least one daily cleaning of the temperature core
probe.
3.3 CLEANING THE CONDENSER UNIT
All the cleaning operations must be carried out when the unit is off, taking off the electric tension from
both the device and the condensing unit. Only qualifi ed staff shall carry out the cleaning operations.
For the cleaning and maintenance of the parts made of stainless steel, follow the below recommendations,
considering that the fi rst and basic rule is to guarantee the no-toxicity and the maximum hygiene of the treated
32
It is essential to keep daily clean the blast chiller room probe. All the pro-
cedures must be carried out with the stationary unit removing the tension
from both the refrigerated item and the condensing unit. We recommend
to rinse carefully the probe with clean water and with hygienized solution.
Refer to the same methods and detergents for cleaning named in the pre-
vious paragraph.