Squeegee Adjustment - Sprintus Tortuga Mode D'emploi

Photo 25
A) Metal retainer for front rubber blade
B) Front rubber blade

7.8 SQUEEGEE ADJUSTMENT

The two wheels at the sides of the squeegee (
Photo 26 -A ) and the central wheel ( Photo 27
-A ) are to adjust the pressure of the squeegee to
the floor.
These adjusting wheels are eccentric; unlocking
the fixing nut ( Photo 26 -B, 27 - B ) it is possible
to rotate the wheel up or down, in order to change
the squeegee pressure on the floor.
When the squeegee is perfectly adjusted, the rear
squeegee blade, sliding as it moves, bends in all
points forming an angle of 45° with the floor.
Changing properly the wheels position it is pos-
sible to adjust the squeegee pressure; the squee-
gee drying must be uniform along the entire drying
line; damp patches mean that drying is insufficient;
rotate the adjusting wheels to optimize drying.
7 - OPERATING INFORMATIONS
A
B
A
Photo 26
A) Eccentric wheel for squeegee pressure
adjustment - side wheel
B) Fixing nut of the eccentric wheel
B
A
Photo 27
A) Eccentric wheel for squeegee pressure
adjustment - central wheel
B) Fixing nut of the eccentric wheel
41
B