Work Schedule Editor; Screwing Parameter Database Field; New Screwing Parameter - Bosch CRR 320 Consignes D'utilisation

Angle limit values (item 2)
Item Conditions
Minimum value >= 0°
Nominal value <= Maximum value
>= Minimum value
Maximum Value <= 999°
Close window (Item 3)
The Preset changes made are rejected if the window is
closed by way of the button (item 5) or the "x" in the
title bar.
Save Preset (Item 4)
Clicking onto the button transfers the Preset settings to
the wrench and the window is closed.
Measurement direction (Item 5)
The selection box can be used to specify the measu-
rement direction. The wrench only displays measured
values if it is subjected to load in this direction of rota-
tion.
Robert Bosch GmbH
Specifications for Preset mode | CRR 320 | 39

23. Work schedule editor

The work schedule editor is made up of two fields. The
top field contains the draft field in which work schedu-
les can be generated and transferred to the wrench.
The lower field presents the screwing parameters
stored in a database and available for the generation of
a work schedule.
23.1

Screwing parameter database field

Fig. 14: Screwing parameter database field
1) New work schedule
2) Edit work schedule
3) Erasing work schedule
As an alternative to using buttons 1-3, the following
functions can also be called up by way of the context
menu of the table.This first involves the selection of one
or more lines. A right mouse click on the header of one
of these lines opens the context menu. The correspon-
ding function is implemented with a left mouse click.
i
Add to draft and Remove apply to all the lines
marked. Even if several lines have been selected,
Remove only applies to the line displaying a black
triangle in the header.
23.2

New screwing parameter

In terms of function, the fields marked
to the Preset dialog panels.
Fig. 15: New screwing parameter
en
correspond
|
0 986 629 502 2015-02-16