Automatic Work Schedule; Termination Of Work Schedule; Menu Item: Info; Exit From Info Menu - Bosch CRR 320 Consignes D'utilisation

10.2

Automatic work schedule

If an "automatic" work schedule has been generated
and stored in the CRR 320, this work schedule is imple-
mented in the sequence in which it was generated with
the aid of the software. The acknowledgement key
must be pressed once to start execution of the work
schedule. Following confirmation, the programmed
limit values can be displayed with the navigation keys
or .
The completion of a work schedule is displayed with
"Work schedule over" (refer to Section 21 "Settings",
Item 5).
10.3

Termination of work schedule

Execution of a work schedule can be terminated with
the cancel key .
In automatic mode, the key lock must not be activated
(Section 21 Settings, Item 7)
i
In the event of termination during the course of
execution of a work schedule, the last position
within a work schedule is not stored. This means
that on re-starting, the work schedule commences
again at para. 00. In the event of termination of an
individual screwing parameter with several screw-
ing operations, the number of screwing operations
already performed is not stored. This means that
on renewed call-up, this screwing parameter would
commence again with screwing operation 1.
Exit from work schedule
On completion of all (automatic mode) or individual
(manual mode) screwing operations, the cancel key
can be used to exit from the work schedule.
Robert Bosch GmbH
Menu item: Work schedule | CRR 320 | 31

11. Menu item: Info

The following information is displayed in the Info menu:
R
Battery status
R
Date / time
Fig. 7: Menu item: Battery status, Date, Time
Use the navigation keys
main menu.
In the main menu, select the menu item "Info" with the
navigation keys or
Confirm selection with the acknowledgement key
11.1

Exit from Info menu

The cancel key can be used to exit from the Info
menu.
en
or to switch to the
.
|
0 986 629 502 2015-02-16
.