Troubleshooting - Sonnenkonig WARMEPILZ RATTAN Mode D'emploi

Service
Only qualified service personnel should repair gas diffusers and associated components.
Caution: Always allow the heater to cool down before putting it into operation.
EN

6 Troubleshooting

PROBLEM
Burner does not ignite
Burner flame is low
Thick black smoke
Odour of gas with extre-
mely yellow flame tip
The glow of the heater is
excessively uneven
The heater makes
popping noises
Carbon enrichment
Any modification or repair to the device must be carried out by a qualified person.
Since the development of the produced devices is constantly progressing, it may happen that your
product differs slightly from the one described.
Possible reason
• Propane cylinder is frozen
• Blockage in the orifice plate
• Control knob is not in position ON
• The gas pressure is low
• The outside temperature is less
than 5º C and the tank is less
than 1/4 full
• Control button fully on
• Spiders and insects nest in burn-
ers or openings
• Blockage in the burner
• Spiders and insects nest in burn-
ers or openings
• Spiders and insects nest in burn-
ers or openings
• Spiders and insects nest in burn-
ers or openings
• Dirt or film on reflector and
burner shade
60
Solution
• Wait until the propane cylinder
warms up and defrosts
• Unblock
• Turn knob to ON
• Close cylinder valve and replace
cylinder
• Use a full cylinder
• Check burner and orifice plates
for clogging
• Clean burner and openings
• Remove blockage and clean
burner inside and outside
• Clean burner and openings
• Clean burner and openings
• Clean burner and openings
• Clean reflector and burner
shade