Secure the rod (E) to the upper component (F) with the
5.
M6*35mm long screw (1).
Note: The control panel should be in the opposite direction to
the fuel filler flap.
Protective cover from the reflector panel (A) and the
6.
Remove reflector plate (B).
Note: To ensure correct alignment of the reflector top plates, it
may be necessary to loosen the pre-assembled screws before
installation and tighten them again after completion.
5.
Fasten the plates together using M6*10mm (3) screws and Ø6 washers (3). Tighten the
7.
screws with the cap nuts (3).
Fasten the plates to the bottom of the panel with M6*10mm (6) screws and Ø6 washers (6).
8.
Tighten the screws with the cap nuts (6).
9.
Place the unit on a stable raised surface at the side.
Fasten the spacers with Ø8 washers (5).
10. Place additional washers (3) on the spacers and place the reflector on the spacers.
Fasten the reflector with wing nuts (3).
Note: Do not overtighten.
8.
6.
9.
55
EN
7.