Maintenance; Maintenance Schedule - Husqvarna K 7000 Manuel D'utilisation

Introduction
WARNING:
safety chapter before you do maintenance
on the product.
For all servicing and repair work on the product, special
training is necessary. We guarantee that professional
repairs and servicing is available. If your dealer is not a
Clean
Function inspection
Safety devices on the product on page 10 .
* Refer to
To install the cutting blade on page 16 .
** Refer to
To clean externally
WARNING:
washer to clean the product.
• Flush the product externally with clean water after
each day of operation. If it is necessary, use a brush.
To do a general inspection
• Make sure that the nuts and screws on the product
are tightened.
• Make sure that the cables on the product are not in a
position where they can become damaged.
• Examine the electrical parts for damage. Do not
operate a product that has damaged electrical parts.
26

Maintenance

Read and understand the
Daily
External cleaning
General inspection
Water delivery system
Throttle lockout*
Blade guard and SmartGuard*
Cutting blade**
Do not use a high-pressure
service agent, speak to them for information about the
nearest service agent.
For spare parts, speak to your HUSQVARNA dealer or
service agent.

Maintenance schedule

The maintenance schedule shows the necessary
maintenance of the product. The intervals are calculated
on daily use of the product.
Weekly or every 40 hours
Vibration damping system*
Drive belt
To adjust the tension of the drive belt
The tension of the drive belt is correct when the
adjustment nut is opposite the mark on the drive belt
cover.
Tighten a new drive belt after 1 hour of operation.
Monthly
Drive wheel
1635 - 003 - 20.08.2021