Toothed Blades - Husqvarna K 7000 Manuel D'utilisation

A
WARNING:
blades with greater blade thickness than
recommended maximum, refer to
Recommended cutting blade dimensions on
page 29 .
WARNING:
and worn blades may cause increased wear
on the side of the segments. Replace the
blade before it is worn out.

Toothed blades

WARNING:
such as wood cutting blades, circular
toothed blades, carbide tipped blades, etc.
The risk of kickback is significantly increased
and tips can be torn off and thrown at high
speed. Carelessness can result in serious
personal injury or even death.
WARNING:
requires a different type of guarding for
carbide tipped blades not available on power
cutters – a 360 degree guard. Power Cutters
(this saw) use diamond blades and have a
different guarding system which does not
provide protection against the dangers
presented by wood cutting blades.
Use of this power cutter with a carbide tipped blade is a
violation of work safety regulations.
Due to the hazardous nature and exigent circumstances
involved with fire fighting and rescue operations
conducted by the various highly trained public safety
forces, safety professionals (fire departments),
Husqvarna is aware that they may use this power cutter
with carbide tipped blades in certain emergency
situations due to the ability of carbide tipped blades to
cut many different types of obstructions and materials in
1635 - 003 - 20.08.2021
Do not use diamond
Some cutting situations
Never use toothed blades
Government regulation
combination without having to take time to switch blades
or machines. When using this power cutter be aware at
all times that carbide tipped blades are more kickback
prone than diamond blades if not used properly. Carbide
tipped blades can also throw pieces of material away
from the blade.
For these reasons, a power cutter equipped with a
carbide tipped blade should never be used except by
highly trained public safety professionals who are aware
of the risks associated with its use and then only in
those exigent circumstances when other tools are
deemed inefficient and ineffective for fire or rescue
operations. A power cutter equipped with a carbide
tipped blade should never be used to cut wood in non-
rescue operations.
To examine the spindle shaft and the
flange washers
CAUTION:
flange washers with a minimum diameter of
105 mm/4.1 in.
WARNING:
or dirty flange washers. Use only flange
washers of the same dimension. Incorrect
flange washers can cause the cutting blade
to become damaged or come loose.
Examine the spindle shaft and the flange washers when
you replace the cutting blade.
1. Make sure that the threads on the spindle shaft are
not damaged. Replace damaged parts.
2. Make sure that the areas of contact on the cutting
blade and the flange washers are not damaged.
Replace damaged parts.
3. Make sure that the flange washers are clean and of
the correct dimension.
4. Make sure that the flange washers move freely on
the spindle shaft.
Use only HUSQVARNA
Do not use defective, worn
15