Telescopic Rod & Utensil Rail Installation - Zephyr Trapeze CTP-E36CSX Guide D'utilisation, D'entretien Et D'installation

ZEPHYRONLINE.COM
Telescopic Rod & Utensil Rail Installation
Telescopic Rod Installation (FIG. F)
1. Install telescopic rod (thicker end down) into coupler on top of hood
and secure by (1) M4*4 set screw for each rod.
2. Extend inner telescopic rod to ceiling coupler and attach by (1) M4*4
set screw for each rod.
3. Secure telescopic rods together at top of outer rod by (1) M4*4 set
screw for each rod set.
FRONT
Utensil Rail Installation (FIG. G)
1. Attach utensil rail to long side of hood canopy. A small hole has been pre-drilled into the canopy
to provide a starting point to attach the first utensil rail post. After the first post is lined up with the
hole, gently slide the rest of the rail onto the canopy. Use caution and be careful not to scratch
the stainless steel of the canopy when performing this step.
2. Secure utensil rail to hood canopy by (1) M4*4 set screw pre-installed into each post. Repeat step
for other side of canopy.
Trapeze Use, Care, and Installation Guide
Installation Instructions
Set screw
BACK
FIG. G
Set
screws
Tool
FIG. F
17