Chauvin Arnoux C.A 6545 Notice De Fonctionnement page 41

If the measurements are unstable, it is possible to use the SMOOTH function (see § 4.5).
Pressing on a V-TIME key during the measurement alternatively displays the measurement time and the
exact voltage generated on the small display (see § 4.2).
The stopping of the measurement is caused by pressing the STOP key.
After the measurement stops, the main result remains displayed.
It is possible to scroll through all the other results available on the main display using the R-DAR-PI-DD
key. This key may also be used before the triggering of the measurement (see § 4.3).
If the "Programmed time test"
measurements memorised automatically (see § 4.2 and 4.3).
If the ALARM function is activated, a buzzer will go off as soon as the measurement exceeds the
programmed threshold in the SET-UP configuration menu (see § 4.4).
Display of values after a measurement
The indications below may be displayed:
R-DAR-PI-DD key
Main
display display
Resistance duration (min. sec)
DAR duration (min. sec)
PI duration (min. sec)
*
DD duration (min. sec)
Current duration (min. sec)
**
Capacity
R(t) duration (min. sec)
*
The value of DD is displayed only one minute after the measurement stops
**
The capacity measurement (µF) is displayed only after the measurement stops and the circuit
discharges
mode was selected, the R (t) key is used to access all the intermediate
Small
if the MR key is activated (C.A 6547)
date, time, test voltage, OBJ: TEST.
date, time, test voltage, OBJ: TEST.
date, time, test voltage, OBJ: TEST.
date, time, test voltage, OBJ: TEST.
last test voltage
41
V-TIME key
Small display