Wayscral ANYWAY E-450 Notice D'utilisation page 24

Conditions of use for this power-assisted bicycle
This power-assisted bicycle is designed for urban, suburban and off-road use and can be used in towns,
on the road or on a paved surface where the tyres are always in contact with the ground. It is equipped
with power assistance that will make all your daily trips easier, so you can go further and for longer.
Your power-assisted bicycle is an adult bicycle for people over the age of 14. If the bicycle is used by a
child, responsibility falls to the parents who must supervise and ensure that the user is able to use the
bicycle safely.
Your bicycle can be used on unpaved or damaged surfaces. It has also been designed for "off road"
use. Your bicycle has not been designed for competitive use. Failure to comply with this intended use
may result in a fall or an accident and may prematurely and irremediably deteriorate the condition of
your power-assisted bicycle.
Your power-assisted bicycle is not a moped. The aim of the assistance is to provide a complement to
your pedalling. The moment you start pedalling, the engine will start and help you move forward. The
assistance varies according to the speed of the bicycle, significant at start-up, less so once the bicycle
has got going and then disappears when the bicycle reaches 25 km/h. The assistance switches off as
soon as one of the two brake levers is activated or the speed exceeds 25 km/h. It will automatically
resume below 23 km/h with the pedalling.
It must be properly maintained according to the instructions in this user guide.
WARNING: As for any mechanical component, a power-assisted bicycle is subject to
high stress and will wear out. The different materials and components can react
differently to wear or ageing. If the expected service life of a component has been
exceeded, it may suddenly break, presenting a risk of injury to the cyclist. Cracks,
scratches and discolouration in areas under high stress indicate that the
component has exceeded its service life and should be replaced.
Recommendation: Safe use and safety tips
Before using your power-assisted bicycle, make sure that it is in good working order. Pay particular
attention to the following points:
•
The riding position is comfortable
•
Nuts, screws, clamping levers, tightening components
•
The brakes are working properly
•
The handlebar's range of movement is correct, without excessive play and correctly attached
to the stem
•
The wheels are not blocked by anything and the bearings are properly adjusted
•
The wheels are correctly tightened and attached to the frame/fork
•
The tyres are in good condition and inflated to the correct pressure
•
The condition of the wheel rims
•
The pedals are firmly attached to the chain set
•
How the transmission works
•
The reflectors are correctly positioned.
24