Mounting The Hood - Zephyr Titan AK7636BS Guide D'utilisation, D'entretien Et D'installation

Installation Instructions

Mounting the Hood

1. Measure from range top to hood bottom and
mark line A. (24" minimum from range top).
2. Plum and mark center line. Mark mounting
height line B (15" from line A). Mark mounting
height line C (4-3/4" from line A).
3. Mark mounting spread from C/L on line B and
C according to diagram.
4. Fasten (2) 6# x 2" screws into studs on line B.
Fasten (2) or (4) 6# x 2" screws into studs on
line C. Do not fasten screws all the way, leave
approximately 3/8" exposed.
NOTE: Wood blocking may need to be added
behind the drywall if no studs are present. Wall
anchors may also be used but check local
codes for compliance. Failure to use suitable
wall anchors and screws to hold the weight
of the hood could result in personal injury or
damage to cooking surface or counter.
5. Install round duct collar with backdraft damper
to top or rear of hood by (4) M4x8 screws.
6. If ducting hood through rear of hood body, cut
duct access hole in wall and prepare ducting.
7. Hang hood onto wall mounted screws and
tighten. (FIG. A #1)
8. Center and attach duct cover bracket to wall below ceiling or soffit using (2) 6# x 1-1/2" screws.
9. Prepare and connect electrical and install duct work and duct tape.
10. Power up hood and check for leaks around duct tape.
11. Place telescopic duct covers onto hood and extend inner (top) duct cover upwards and secure to
duct cover bracket using (2) M4x8 screws.
14
(36", 42")
11-13/16"
(48", 54", 60")
17-11/16"
B
C
4-3/4"
(36") 25-1/4", (42") 31-3/16"
(48") 19-1/16", (54") 25-1/16"
(60") 30-7/8"
(48") 37-3/16", (54") 43-1/8", (60") 49"
C/L
2
FIG. B
Titan Use, Care, and Installation Guide
P R O
T I TA N
WA L L
Duct Cover
Bracket
15"
A
24" min.
1