Technical Data; Noise Information; Vibration Information - Worx AXIS WX550 Mode D'emploi

1. ON/OFF SWITCH
2. LOCK-OFF BUTTON
3. HAND GRIP AREAS
4. PIVOT RELEASE BUTTON
5. MOTOR COVER
6. PENDULUM FUNCTION CONTROL
7. PROTECTION FINGER
8. LED WORK LIGHT (SEE FIG. H)
9. BLADE HOLDER
10. FOOT PLATE
11. BASE PLATE
12. BATTERY PACK *
13. BATTERY PACK RELEASE BUTTON
*Not all the accessories illustrated or
described are included in standard delivery.

TECHNICAL DATA

Type WX550 WX550.1 WX550.9 (5-designation
of machinery, representative of Saw)
Rated voltage
Charger voltage
No load speed
Stroke length
Cutting capacity
Wood
Jigsaw
PVC pipe
mode
Steel plate
Wood
Rep saw
PVC pipe
mode
Steel
pipe
Machine weight
**Voltage measured without workload. Initial
battery voltage reaches maximum of 20 volts.
Nominal voltage is 18 volts.
20V Li-Ion multi-purpose saw
WX550
WX550.9
WX550.1
20V Max**
100-240V~50/60Hz /
0-3000/min
20mm
50mm
50mm
4mm
100mm
127mm
76mm
1.9kg 1.5kg

NOISE INFORMATION

A weighted sound pressure
A weighted sound power
K &K
pA wA
Wear ear protection

VIBRATION INFORMATION

Vibration total values (triax vector sum) deter-
mined according to EN 60745:
Vibration emission value
Cutting sheet
a
h,M
metal
Uncertainty K = 1,5m/s²
Vibration emission value
a
Cutting boards
h,B
Uncertainty K = 1.5m/s
Vibration emission value
Cutting wooden
a
h,WB
beams
Uncertainty K = 1.5m/s²
The declared vibration total value may be used for
comparing one tool with another, and may also be
used in a preliminary assessment of exposure.
WARNING: The vibration emission value
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used dependant on the following
examples and other variations on how the tool is
used:
How the tool is used and the materials being cut.
The tool being in good condition and well
maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately
managed.
WARNING: To be accurate, an estimation
of exposure level in the actual conditions
of use should also take account of all parts of the
operating cycle such as the times when the tool
is switched off and when it is running idle but not
actually doing the job. This may significantly reduce
the exposure level over the total working period.
L = 79,7dB(A)
pA
L = 90,7dB(A)
wA
3dB(A)
= 4,805m/s
2
= 5,495m/s
2
²
= 5,535m/s
2
EN
7