Component List; Technical Data; Noise Information; Vibration Information - Worx WX500 Notice Originale

Lock
Unlock
Waste electrical products must not be
disposed of with household waste.
Please recycle where facilities exist.
Check with your local authorities or
retailer for recycling advice.

COMPONENT LIST

1. LOCK-OFF BUTTON
2. ON/OFF SWITCH
3. TOOL-FREE BLADE CLAMP LEVER
4. PIVOT FOOT PLATE
5. BLADE
6. BATTERY PACK*
10 7. BATTERY PACK RELEASE BUTTON*
8. FOOTPLATE ADJUSTMENT LEVER
* Not all the accessories illustrated or
described are included in standard delivery.

TECHNICAL DATA

Type designation WX500 WX500.9 (500-519 -
designation of machinery, representative of
Reciprocating Saw)
Voltage
No-load speed
Stroke length
Wood
Cutting
Steel
capacity
PVC pipe
Machine weight
** Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal
voltage is 18 volts.
Cordless Reciprocating Saw
WX500 WX500.9
20V Max**
0-3000/min
20mm
130mm
10mm
190mm
2.09kg 1.68kg

NOISE INFORMATION

A weighted sound pressure L
K = 5dB(A)
pA
A weighted sound power
K = 5dB(A)
wA
Wear ear protection.

VIBRATION INFORMATION

Vibration total values (triax vector sum)
determined according to EN 62841:
Vibration emission value
a
Cutting boards
h,B
Uncertainty K = 1.5m/s²
Vibration emission value
Cutting wooden
a
h,WB
beams
Uncertainty K = 1.5m/s²
The declared vibration total value and the declared
noise emission value have been measured in
accordance with a standard test method and may be
used for comparing one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a
preliminary assessment of exposure.
WARNING: The vibration and noise
emissions during actual use of the power tool
can differ from the declared value depending on the
ways in which the tool is used especially what kind of
workpiece is processed dependant on the following
examples and other variations on how the tool is
used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well
maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
= 79.2dB(A)
pA
L = 90.2dB(A)
wA
= 5.353m/s
2
= 5.720m/s
2
EN