Safety Instructions - Grammer LINEA Manuel D'utilisation

•
Before you remove the driver's seat, disconnect all plug-in connections between the seat and
the vehicle supply network
in connectors, make sure they are tight (dust, water).
•
Screw connections must be
be loose bolts or other faults.
•
If the seat is equipped with seatbelts, check them for correct function.
•
Seatbelts must be fastened
Where seatbelts are fitted to the driver' s seat, the
by specialist personnel after an accident has occurred.
•
Retro-fitting of driver's seats with integrated seatbelts is only admissible after consulting the
vehicle manufacturer and with proper fitting by authorized workshops.
•
If you note that the seat does not function correctly (for example a defective seat suspension;
improper curvature of the lumbar support or damaged bellows),
If you fail to do so, your health may be affected and the
•
Do not indent the bellows while there is load on the driver's seat.
–
•
Make sure that the
•
The driver' s seat is
•
Any conversion or retrofitting on a driver' s seat made by
exclusively in
adherence with the applicable operating, maintenance and installation instructions and in
compliance with all relevant national regulations.
•
and the proper function of the driver' s seat or mounted parts can no longer be guaranteed.
•
The driver's seat is free of maintenance. Worn parts such as rollers, absorbers and the
fixation must be checked from time to time. If the driver's seat is not adjusted to the medium
position in case of load, the system pressure at the supply line or the function of the control
valve for medium position adjustment have to be checked.
•
Correct functioning of the driver's seat is essential to your health. Therefore, take adequate
care of your seat to ensure that it functions correctly.
•
To ensure proper function of the driver's seat and to prevent damages of the pneumatic
spring, adjust the loaded driver' s seat to the highest height position (see "Height adjustment")
after it has been fitted into the vehicle. Please make sure that the normal working pressure is
available in the vehicle's air supply system. In case of non-observance, the guarantee will
expire.
•
, you must check if all seat settings selected guarantee a
the vehicle.
GB
.
after an accident.
to arrange for repairs to be carried out.
–
and must be protected against splashes of water!
by
bear the risk of

Safety instructions

. When you replace the plug-
. If the seat wobbles there may
and
remains free of
or
must be checked
.
or
AG must be performed
and in
or
19
.
of