EdilKamin MYA Installation, Usage Et Maintenance page 30

I
H
g. 7
G
M
g. 9
g. 11
Q
g. 1
R
INSTALLATION
I
L
g. 8
N
P
g. 10
g. 12
S
- Remove the diaphragm ( - g. 7) and, if necessary the per-
forated lower rear panel as well (I - g. 7).
- Slacken the clamp (L - g. 8) and remove the outlet ue pipe
(L1 - g. 8).
- osition the inspection elbow (M - g. 9) and
clamp slackened previously.
- Remove the cast iron cap (N - g. 10) resting on the top and
t the ue pipe outlet ( - g. 10) from the side of the stove.
- osition the two plating closers ( - g. 11) around the ue
pipe outlet and them using the screws.
- Fit the side removed previously (for the version with glass
sides, put the gaskets and small parts back in place as shown in
gure 12).
- Fit the ue pipe (R - g. 1 ) (not supplied) over the outlet and
it using the clamp (S - g. 1 ) (not supplied).
- 30
-
it using the