Setting Bevel Angle; Setting Depth Adjustment; Maintenance And Cleaning; Technical Data - Batavia MAXXPACK 18V BT-CCS003 Mode D'emploi

• Fit the required blade, making sure the
direction indicator on the face of the blade
is in the same direction as the Direction
Indicator (23).
• Re-fit the Blade Flange, washer and Blade
Securing Bolt. Press in the Spindle Lock
Button and tighten using the hex key.
• Ensure the blade is secure before use.

SETTING BEVEL ANGLE

• This saw is equipped with a tilting Base
Plate (14). This allows bevel cuts to be
made.
• Alter the angle of the Base Plate by loos-
ening the Bevel Angle Locking Knob (21).
The Base Plate will now be free to pivot.
• Select the angle required (0 – 45°) using
the Bevel Angle Gauge (22) and retighten
the Bevel Angle Locking Knob.
• Ensure accuracy by checking the angle
between the Blade (13) and the Base
Plate using a suitable protractor.

SETTING DEPTH ADJUSTMENT

• This saw is equipped with a depth adjust-
ment mechanism.
• Alter the depth of the cut by loosening the
Depth Locking Knob (11). The Base Plate
(14) is now free to adjust to the required
depth.
• Adjust the Base Plate to the required
depth using the Depth Scale (12) or a ruler
and retighten the Depth Locking Knob.
• When set correctly, the blade teeth should
project approximately 3mm from the
underside of the material being cut.

MAINTENANCE AND CLEANING

WARNING: Always disconnect from the mains
power supply, before carrying out any mainte-
nance/ cleaning of the charger. Remove the
battery before carrying out any maintenance/
cleaning of the tool.
Cleaning
• Keep safety devices, ventilation openings
and the motor housing as free as possible
from dirt and dust. Rub the electric power
tool with a clean cloth or blow over it with
low pressure compressed air.
• We recommend that you clean your elec-
tric power tool immediately after each use.
• Clean the electric power tool regularly with
a damp cloth and somewhat soft soap.
Do not use any cleaning or solvent materials;
these can attack the device's plastic compo-
nents. Make sure that no water can get inside
the electric power tool.
Maintenance
There are no inner parts of the tool which need
maintenance.

TECHNICAL DATA

No load speed . . . . . . . . . . . 3650 min
Blade size . . . . . . . . . . . . . Ø 165 mm
Blade bore . . . . . . . . . . . . . . Ø 16 mm
Max depth of cut . . . 0° :50mm / 45° :36mm
Dimensions . . . . . . . . . . 32 x 18 x 25 cm
Weight . . . . . . . . . . . . . . . . . 2.77 kg
Sound Pressure Level L
Uncertainty K . . . . . . . . . . . . . . 3 dB
pA
Sound Power Level L
WA
Uncertainty K . . . . . . . . . . . . . . 3 dB
WA
Hand Arm Vibration (No Load) . . . 1.264 m/s
Uncertainty K . . . . . . . . . . . . . .1.5m/s
English
. . . . .81.47 dB(A)
pA
. . . . . 93.47 dB(A)
-1
2
2
9