Required Tools For Installation - Haier GE Appliances USYM09UCDS Manuel D'utilisation

Installation Instructions: List of Materials
• 17mm, 22mm, 26mm or Adjustable Wrench
• #2 Phillips Screwdriver
• Drill
• R-410A Approved Flaring Tool
• Hex Wrench
• Hole Saw 2 1/4"
• Level
• Manifold Gauge
• Measuring Tape
• Micron Gauge
• Mini-Split Adapter (5/16"F to 1/4"M)
• Nitrogen*
• Condensate connecting tube
• Clamp
Model
USYM09UCDS (A)
USYM12UCDS (A)
USYM18UCDS (A)
USYM24UCDS (A)
NOTE: A wired controller is required and must be ordered separately
31-5000493 Rev. 1

Required Tools for Installation

Supplied with Unit
Supplied by Installer
Liquid (inch) Vapor (inch)
1/4 3/8
1/4 3/8
1/4 1/2
3/8 5/8
• Pipe Cutter
• Razor Knife
• Reamer
• Sealant, non-expanding (for line set opening)
• HVAC leak solution or refrigerant leak detector
• Stud Finder
• Torque Wrench and Back-up Wrench
• Vacuum Pump
• Wire Strippers
• Refrigerant Scale
• Usual and customary HVAC hand tools
• Flare nuts (2)
• Insulation
• Insulated copper tubing
• 14/4 (14 gauge – 4 conductor) stranded copper cable
• 1 and 1/4 inch PVC for condensate
• Insulation for condensate drain
• 3/8 threaded rod, washers and nuts
• R410A Refrigerant
5