Intended Use; Items Supplied - Hilti GX 2 Mode D'emploi Original

▶ If a person has inhaled gas, take the person into the open air or into a well-ventilated area and place the
person in a comfortable position. Consult a doctor if necessary.
▶ Call a doctor if the person is unconscious. Bring the person into a well-ventilated area and place the
person in the stable recovery position (i.e. lying on the side). If the person is not breathing, administer
artificial respiration and, if necessary, supply oxygen.
▶ After eye contact with gas, rinse the open eyes thoroughly under running water for several minutes.
▶ After skin contact with gas, wash the contact area carefully with soap and warm water. Subsequently
apply a skin cream.
General instructions concerning personal safety
▶ Take care to adopt an ergonomic body position. Work from a safe stance and take care to stay in balance
at all times. This will allow you to control the fastening tool better, even in unexpected situations.
▶ Keep other people away from the working area, especially children.
3 Description
3.1 Overview of the product
Fastener guide
@
Slider for fastener driving depth adjustment
;
and for releasing the fastener guide
Belt hook
=
Safety trigger
%
Magazine lockbutton
&
Support leg
(
Magazine
)

3.2 Intended use

The product described is a gas-actuated fastening tool. It is designed to drive suitable fasteners (nails) into
concrete, steel, concrete-block masonry, sand-lime block, rendered masonry and other materials suitable
for use of the direct fastening technique.
The fastening tool, gas can, battery and fasteners form a technical unit. This means that trouble-free
fastening with this fastening tool can be ensured only when it is used together with the fasteners, gas cans
and batteries specially manufactured for it by Hilti. The fastening and application recommendations made
by Hilti apply only when these conditions are observed.
The fastening tool is for hand-held use only.
▶ Use only Hilti Li­ion batteries of the B 12 series with this product.
▶ Use only Hilti battery chargers of the C 4/12-50 series for charging these batteries.

3.3 Items supplied

Gas-actuated fastening tool with fastener guide, 2 batteries, charger, toolbox and operating instructions.
Other system products approved for use with this product can be found at your local Hilti Center or online
at: www.hilti.com
3.4 Fastener guide
The fastener guide holds the studs or, respectively, guides the nails and, when the tool is actuated, thus
directs the fasteners into the supporting material at the desired position.
3.5 Slider for fastener driving depth adjustment and for releasing the fastener guide
The slider can be used to reduce the depth to which the fastener is driven. In the EJECT position, it releases
the fastener guide for removal.
Status
+
­
EJECT
4 English
Printed: 11.09.2017 | Doc-Nr: PUB / 5373611 / 000 / 00
1
+
§
/
:
∙
$
£
Meaning
•
•
•
Nail pusher
Cooling air slots
Gas can compartment
Battery release button
Battery charge status display
Gas can status indicator button
Gas can status indicator
Standard fastener driving depth
Reduced fastener driving depth
Fastener guide release