Care And Maintenance; Caring For The Fastening Tool; Cleaning The Fastening Tool - Hilti GX 2 Mode D'emploi Original

8.8 Fitting the support leg
1. Insert the support leg in the locating groove.
2. Pivot the support leg downwards until it engages.
9 Remedying possible malfunctions
9.1 Removing foreign objects from the area of the fastener guide
1. Remove the battery. → page 7
2. Remove the gas can. → page 7
3. Unload the magazine. → page 7
4. Remove the magazine. → page 8
5. Remove the fastener guide. → page 8
6. Remove all foreign objects from the area of the fastener guide.
7. Insert the fastener guide. → page 8
8. Fit the magazine. → page 8

10 Care and maintenance

10.1 Caring for the fastening tool

▶ Clean the fastening tool with a cloth at regular intervals (see also → page 9).
▶ Keep the grip areas free from oil and grease.
▶ Do not use spray equipment, pressure jet washers or running water for cleaning.
▶ Do not use cleaning agents containing silicone.
▶ Do not use sprays or similar lubricating and cleaning agents.
▶ Never operate the fastening tool if the cooling air slots are blocked.

10.2 Cleaning the fastening tool

Note
The fastening tool must be cleaned and serviced regularly. We recommend that a cleaning service is
carried out, at the latest, after driving 25,000 fasteners.
▶ Clean the fastening tool, or have it cleaned, if malfunctions such as misfiring occur increasingly.
▶ For cleaning, use the cleaning set (available as an accessory) and observe the illustrated cleaning
instructions enclosed with it.
10.3 Maintenance
▶ To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your
local Hilti Center or online at: www.hilti.group.
▶ Check all external parts of the fastening tool for signs of damage at regular intervals and make sure that
all the controls function correctly.
▶ Do not use the fastening tool if parts are damaged or if the controls do not function correctly.
▶ Have a defective fastening tool repaired by Hilti Service.
10.4 Checks after care and maintenance work
▶ After maintenance, check that the fastener guide is fitted → page 8.
11 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Printed: 11.09.2017 | Doc-Nr: PUB / 5373611 / 000 / 00
English 9