A
B
D
C
Control Touch Pad (4) with Docking Station
A: Touchscreen user interface
B: „Laser in Operation" display
C: Laser button
D: „Fault" display
3. Use
3B LASER NEEDLE is a low level laser therapy for the treatment of pain-, trigger- and acupuncture points. It is intended exclusively
for use in medical practices and clinics and may only be operated under permanent supervision from medical specialists.
4. Contraindications
The following contraindications are referred to in the laser literature:
Absolute:
•
Irradiation of eyes
•
Photosensitivity
•
Tumour patients
•
Open fontanelles and epiphyseal cartilaged in children
•
Thyroid gland hyperactivity
Relative:
•
Pacemaker patients (thorax)
•
Epilepsy(head)
•
Pregnancy (stomach and back regions)
•
Endocrine organs (thorax gland, testicles, ovaries)
Therapy hindrances: deep X-ray treatment, permanent medication, chemotherapy
G
F
E
Laser Unit with connected FOC
E: Laser Unit switch on
F: „Fault" display
G: „Laser in Operation" display
5. Operation
Switch the 3B LASER NEEDLE on at the Control Touch Pad (4) using the LASER button (C). Following the appearance of the 3B
logo, the start menu opens up a few seconds later.
The first time the unit is switched on, the values 12 x 50 mW, CW and 20 minutes are pre-programmed. Otherwise, the last setting is
always retained.
"Start menu" screen
1
2
3
8
"Laser in operation" screen
1
4
18
4
1. For setting the laser power
2. For setting the operating mode
5
3. For setting the duration of the therapy
4. Display of the set values
6
5. Program saving
6. Program calling
7
7. Sound on/off
8. Selection of the laser diodes (red = selected)
9. Establishing wireless connection
9
10. Battery charge level display
1 0
1. Display of the dose rate / activated laser dio
2. Display of the power level setting and the
2
operating mode
3. Therapy duration time counts downwards
2
4. Activated laser diodes appear as bars, in line
05:00
with the defined power setting
3
19