Calcualting The Shutter Speed; Number Of Flashes / Flash Frequency = Shutter Speed - Hahnel MODUS 600RT MKII Manuel D'instructions

Masquer les pouces Voir aussi pour MODUS 600RT MKII:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Calculating the Shutter Speed
During stroboscopic flash, the shutter remains open until
the firing stops. Use the formula below to calculate the
shutter speed and set it on the camera.
Number of Flashes / Flash Frequency
= Shutter Speed
For example, if the number of flashes is 10 and the firing
frequency is 5 Hz, the shutter speed should be at least 2
seconds.
• To avoid overheating and deteriorating the flash head,
do not use stroboscopic flash more than 10 times in
succession
• After 10 times, allow the speedlight to rest for at least 15
minutes. If you try to use the stroboscopic flash more than
10 times in succession, the firing might stop automatically
to protect the flash head. If this happens, allow at least 15
minutes' rest for the speedlight
• Stroboscopic flash is most effective with a highly reflective
subject against a dark background
• Using a tripod and a remote control is recommended.
• A flash output of 1/1 and 1/2 cannot be set for stroboscopic
flash
• Stroboscopic flash can be used with"buLb"
• If the number of flashes is displayed as "--", the firing
will continue until the shutter closes or the battery is
exhausted. The number of flashes will be limited as shown
by the following table.
22
SET
3. Set the flash frequency
and number of flashes
• Press <
Times
button
• Turn the Select Dial
to set the number of
flashes
• Press the <
• Turn the Select Dial to
choose a desired flash
firing frequency
• After you finish
the setting, press
<SET> button and
all the settings will be
displayed.
>
>
H
Z
Modus 600RT

Publicité

Table des Matières
loading

Table des Matières