Remote Control; Practical Advice - ESYLUX MD-W200i Mode D'emploi

Test mode
The time setting and light value switches are located behind
the covering cap. Set the time setting switch (fig. 6.1) to T for
test. During test mode, irrespective of ambient brightness, if
motion is detected, the system will switch ON for 1 second
GB
and OFF for 2 seconds.
The following possibilities are available to adjust the field of
detection to the surrounding area:
• Adjust the range on the left and the sensor field on the right
by mechanically adjusting the internal lens mask (fig. 7).
• Use the supplied covering cap to mask specific areas (fig. 8).
Once you have established the field of detection, turn the
time setting switch to the required ON period (fig. 6.1)
(Impulse 15 seconds - 16 minutes) and adjust the light value
(fig. 6.2) (2 - 2000 lux) according to your requirements.
Impulse means that the device is activated for 1 second
followed by a break of 9 seconds in which no movement is
detected.
NOTE: When turning the light value switch (starting from the
moon symbol), if the current ambient brightness is reached or
exceeded, the focus LED will light up (as a setting aid). The
LED automatically goes out after 2 seconds. Depending on
the set light value and any detected movement, the focus LED
will flash twice. The motion detector also switches the system
on according to the set ON period. Place the covering cap
on the sensor and lock it by turning it gently to the right (fig. 9).
12
5 • REMOTE CONTROL
All settings programmed by remote control are permanently
stored in the memory and will not be lost in the event of a
power failure.
Using the remote control Mobil-RCi-M (fig. 10) the settings
can be easily programmed without needing to climb a
ladder or use any tools. For optimum reception, when
programming the settings, point the remote control at the
motion detector. Please note that if the sun shines directly on
the sensor, the standard detection range of approx. 6 m may
be dramatically reduced owing to the sun's infrared rays.
Acknowledgement of commands
If the command is acknowledged and performed: Focus LED
flashes 3 times.
6 • PRACTICAL ADVICE
• Small animals, nearby trees or bushes moving in the wind
may cause the floodlight to switch on.
• The detector's range can be dramatically reduced by
objects moving towards it, rather than parallel with it.