Preparation For Shipping A - Seagate Scorpion 240 DDS-4 Autoloader Manuel D'installation

A-38
Figure 14 shows how to write-protect a Scorpion 240
magazine. To enable writing to the magazine, move the
switch upward. To protect all tapes in the magazine from
being written to, move the switch down.
Figure 14. Write-protect switch on autoloader magazine
Preparation for shipping
Before shipping the Scorpion 240, you must secure the
autoloader door to prevent damage to the drive. Follow the
procedure below to secure the door as the last step before
switching off the autoloader:
1. Make sure there is no magazine in the autoloader. The
2. Press and hold the Select button for 5 seconds. The LCD
3. Press the Select button four times. The curser (>) will
Scorpion 240 Autoloader Installation Manual
LCD should display the message "NO MAGAZINE."
should show the following menu:
> VERSION
LANGUAG
CONTRAST
move down to the word "DOOR," as shown below:
CONTRAST
AUTO/LD
> DOOR
Write-enabled
Write-protected